Hayabusa Post-Landing & Science Results |
Hayabusa Post-Landing & Science Results |
Jun 17 2010, 02:41 AM
Post
#1
|
|
Merciless Robot Group: Admin Posts: 8785 Joined: 8-December 05 From: Los Angeles Member No.: 602 |
The capsule began its return to Japan a few moments ago as I write this. Seems like a good time to start a new topic for the much-anticipated final results of this epic mission.
-------------------- A few will take this knowledge and use this power of a dream realized as a force for change, an impetus for further discovery to make less ancient dreams real.
|
|
|
Jun 17 2010, 12:41 PM
Post
#2
|
|
Merciless Robot Group: Admin Posts: 8785 Joined: 8-December 05 From: Los Angeles Member No.: 602 |
Perhaps this is unduly optimistic, but I think that it's relatively hard for it not to have at least a trace of dust inside at some point in the ingestion path.
Haven't seen any discussion about or references to the possible electrostatic condition of the spacecraft with respect to Itokawa but there must have been some potential, of course, and probably a bit of dust was raised during the landings. -------------------- A few will take this knowledge and use this power of a dream realized as a force for change, an impetus for further discovery to make less ancient dreams real.
|
|
|
Lo-Fi Version | Time is now: 26th September 2024 - 09:46 AM |
RULES AND GUIDELINES Please read the Forum Rules and Guidelines before posting. IMAGE COPYRIGHT |
OPINIONS AND MODERATION Opinions expressed on UnmannedSpaceflight.com are those of the individual posters and do not necessarily reflect the opinions of UnmannedSpaceflight.com or The Planetary Society. The all-volunteer UnmannedSpaceflight.com moderation team is wholly independent of The Planetary Society. The Planetary Society has no influence over decisions made by the UnmannedSpaceflight.com moderators. |
SUPPORT THE FORUM Unmannedspaceflight.com is funded by the Planetary Society. Please consider supporting our work and many other projects by donating to the Society or becoming a member. |