[X] My Assistant

[Tesheiner]

Dilo,

First of all, let me say again that your vertical projections are an excellent job and a good way to follow the rover progress and match it with MOC images.

Even if it is/was quite easy to match the outcrops seen on your maps with the orbiter imagery, it is true that I was only successful with near features on the range up to 10 meters. Farther outcrops didn’t match, including what I supose is the highway.

What I have found is that there is an error factor on those projections that increases with the distance. In other words, the outcrops look farther than they actually are.

For instance: the feature A I’ve picked on your last “route map” (see below) is supposedly at 13.1 m from the camera.

However, the same feature, which can be identified on the original images from sol 569 (see below), is calculated to be at 11.1m using the MER Parallax Calculator or at 11.74m using the elevation (pitch) angle.

Similar case for the feature B. It is at 41.3m per your “route map” and at 34.8m (plus/minus 2.5m) according to parallax. By taking the elevation angle, the result is 32.6m.

Do you (or anybody else) know which is the reason for this discrepancy, and if it can be corrected?
If it could, I think that those projections would fit orbital imagery even better then now, matching almost all the outcrops seen by the rover up to the Erebus Highway.

[dilo]

Interesting observation, Tesheiner...
I have to check, but possible explaination is that terrain is not flat, so overestimated distance could arise from slightly higher level of the Erebus highway compared to Rover location. This should be easily verifiable through parallax measurements and your elevation measure seems to confirm this model...
Anyway, I must underline that my projection method is far from perfection. In fact, due to difficulty to obtain a perfectly flat horizon with AutoStitch, even absolutely flat terrain should produce some imperfections in estimated distance for some particular azimut values (especially near the edges of the panorama stitch). Finally, remember that dunes can partially/completely hide the far outcrops...
For these reasons, I avoid to extend vertical projections too far.
Thanks.

[dilo]

Based on Tesheiner observation, in my last route map update I made a slight correction on Sol574 new vertical projection.
In pratice, I corrected local slope of the projection plane in order to match distance with parallax value of the small outcrop indicated by red arrow (18.9m).

The correction was pretty small (0.6 deg in East direction) but now Erebus highway appear clearly closer than in Sol569 projection.
Tesheiner, can you make a smart verify on my figures/projection, pls?